Hi Prof.Pfeifer,
I wrote an dynare mod.file, which includes Bayesian estimation.
However when I look into the results, I found that the parameter values (in the surface of workspace) is not what were estimated (in oo_.posterior_mode.parameters), but what I declared in my dynare code file (line 56-69).
Is there anything wrong?
Thanks!
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
question on parameter values...
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
question on parameter values...
by fuyangzhao » Fri May 20, 2016 1:55 pm
- Attachments
-
problem.mod- (18.72 KiB) Downloaded 216 times
- fuyangzhao
- Posts: 48
- Joined: Thu Dec 10, 2015 1:20 pm
Re: question on parameter values...
by jpfeifer » Sat May 28, 2016 7:31 am
The parameters after estimation are not put into the workspace. What you see are old calibrated values. The ones that are currently used are always stored in
- Code: Select all
M_.params
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 14 guests