I am trying to access the page:
http://www.dynare.org/DynareWiki/HowtoLoops which is referred in several posts, but I am getting: "This page does not exist yet. "
Any help please
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
howtoloops page
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
4 posts
• Page 1 of 1
howtoloops page
by aorestrup » Wed Jun 08, 2016 1:55 pm
- aorestrup
- Posts: 5
- Joined: Thu May 26, 2016 3:32 pm
Re: howtoloops page
by jpfeifer » Wed Jun 08, 2016 5:05 pm
What exactly are you looking for? I am not aware of any page like this.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
Re: howtoloops page
by aorestrup » Thu Jun 09, 2016 3:01 pm
I am trying to do a loop over a parameter and save all results - the endogenous variables for each value of such parameter, keeping all other at the same constant values.
In the code attached I can create different values for \taucs but the code is displaying only for its last value and the corresponding endogenous variables. How exactly can I save and have access to all results?
Thanks in advance.
In the code attached I can create different values for \taucs but the code is displaying only for its last value and the corresponding endogenous variables. How exactly can I save and have access to all results?
Thanks in advance.
- Attachments
-
olg_tax2.mod- (3.83 KiB) Downloaded 104 times
- aorestrup
- Posts: 5
- Joined: Thu May 26, 2016 3:32 pm
Re: howtoloops page
by jpfeifer » Sun Jun 12, 2016 4:56 pm
This is not the correct way of looping over Dynare. Please see http://www.dynare.org/phpBB3/viewtopic.php?f=1&t=4891.
Over which command are you trying to loop?
Over which command are you trying to loop?
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests