Hi:
I am replicating a paper but i have trouble with steady state values.firstly,I use fsolve to get steady state values in Matlab,then log-linearizing around the steady state，and use dynare to solve model.
How to deal with the following problems ?
1) fsolve can't converge to a solution x.(exitflag=0 not 1), the the squared 2-norm of the residual is 10e-5 ,if i can't use the "approximate steady state value".
2) how to limit the range of values ,eg. i want to get a positive value,but fsolve return a negative value.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
use fsolve to find steady state values
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
use fsolve to find steady state values
by jack_ct » Sat Jul 02, 2016 7:49 am
- jack_ct
- Posts: 4
- Joined: Sat Dec 26, 2015 8:26 am
Re: use fsolve to find steady state values
by jpfeifer » Sat Jul 02, 2016 5:27 pm
I am not sure I understand the problem, but this suggests that you haven't found the correct steady state of the underlying model in Matlab. Is there a reason you log-linearize by hand instead of using the nonlinear model in Dynare?
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests