Increase number of digits in output

[Sophie]

Dear all,

I have a very basic question: How can I increase the number of digits shown in the output given by Dynare?
Some of the output is very close to zero and I would like to see more than the four digits shown (for the theoretical moments).
I tried using the matlab-command "format long" before running the file but it did not work...

Thanks for your help

[jpfeifer]

That is somewhat tricky. For theoretical moments, you have to go to

Code: Select all

disp_th_moments.m

There you will find calls to dyntable like

Code: Select all

        dyntable(options_,title,headers,labels,z,lh,11,4);

First number at the end is the number of total digits displayed, the last number is the number of decimals. 4 in this case. You need to manually increase it.

[Sophie]

Thank you very much! It was successful.

[jpfeifer]

In

Code: Select all

disp_steady_state.m

the line

Code: Select all

disp(sprintf('%s \t\t %g',endo_names(i,:),steady_state(i)));

needs to be altered from

Code: Select all

%g

to e.g.

Code: Select all

%6g

for six digits