Say we have 7 observed variables. 6 of them need to be demeaned and 1 of them doesn't need to be demeaned. If we use the option 'prefilter=1' then that would demean all 7 series. Is there any way that we can avoid demeaning one of the series.
thanks
abhishek.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Demeaning
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
by measilva » Thu May 01, 2008 2:09 pm
I do not use the option prefilter in Dynare. I usually do data transformation in the Matlab file where the data is stored. This is easier because you can do whatever transformation you need to do in all or some of your observables.
Hope this helps.
Cheers.
Hope this helps.
Cheers.
Marcelo
University of North Carolina
University of North Carolina
- measilva
- Posts: 31
- Joined: Wed Mar 05, 2008 3:47 pm
- Location: University of North Carolina
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests