irf_calibration command

This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location where you will have to reset your password.
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.

irf_calibration command

Postby narges1364 » Tue Jan 03, 2017 10:42 am

Hello everyone!


I want to run a DSGE model with an irf_calibration command. I used version 4.4.3 of dynare, but it doesn't work. Then, I tried to install the unstable version of dynare to support this command. This version doesn't work at all with this error:


Error using check_matlab_path (line 103) You put all the dynare/matlab subfolders in matlab's path! Only the dynare/matlab folder (without subfolders) should be in the path, Dynare will automatically add any required subfolders in the path. Error in dynare (line 60) check_matlab_path(change_path_flag)

I removed all the previous versions of dynare from set path. Yet it doesn't work. How can I run this code? I will be glad if I could have your help.
Last edited by narges1364 on Fri Jun 23, 2017 6:22 pm, edited 1 time in total.
narges1364
 
Posts: 4
Joined: Fri Dec 18, 2015 6:44 pm

Re: irf_calibration command

Postby jpfeifer » Tue Jan 03, 2017 2:30 pm

This is still a path issue. Please make sure that you remove all paths to Dynare and then add only the matlab subfolder of the unstable version to your path.
------------
Johannes Pfeifer
University of Cologne
https://sites.google.com/site/pfeiferecon/
jpfeifer
 
Posts: 6940
Joined: Sun Feb 21, 2010 4:02 pm
Location: Cologne, Germany

Re: irf_calibration command

Postby hamideconomy80 » Sun Feb 26, 2017 6:46 pm

سلام
بندهای زیر رو بردار از مدلت بعد اجرا که شد
یکی یکی بهش بندهارو اضافه کن
تا ببینی مشکل از کجاست
مدلت اجرا میشه اما نمودار شوکه ات یکمی بده
//irf_calibration;
//y(1:10), epsilon_t_w, -;
//y(1:10), epsilon_t_k, -;
//end;
hamideconomy80
 
Posts: 16
Joined: Thu Nov 12, 2015 6:36 am

Re: irf_calibration command

Postby narges1364 » Thu Jun 22, 2017 12:07 am

سلام


بله مشکلم همینه که توابع عکس العمل آنی بسیار بد هستند. حتی در بسیاری موارد کلا نتایج برعکسه.
این کاری که فرمودید رو انجام دادم اما فایده ای نداره
البته کمی مدل رو تغییر دادم اما باز هم نمی تونم روابط صحیح بین متغیرها رو استخراج کنم. و برای این دستور باز هم با همون خطا مواجهم.
narges1364
 
Posts: 4
Joined: Fri Dec 18, 2015 6:44 pm


Return to Dynare contributions and examples

Who is online

Users browsing this forum: No registered users and 4 guests