Does anyone know a trick to debug in version 4?
I keep getting a error message "syntax error, unexpected COMMA, expecting EQUAL" after a run my code. What I want is to see in which line of the code the problem is exactly.
Even when I get rid off of all COMMA's in my mod file, I still get this message.
P.S.: when I run the same code in version 3 and it works perfectly.
Any thoughts will be appreciated.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
How to debug in Version 4?
Forum rules
As Dynare 4 is the current Dynare version, there forum is now close. Post new question in the Dynare Help Forum.
As Dynare 4 is the current Dynare version, there forum is now close. Post new question in the Dynare Help Forum.
3 posts
• Page 1 of 1
How to debug in Version 4?
by measilva » Fri Jul 25, 2008 6:05 pm
Marcelo
University of North Carolina
University of North Carolina
- measilva
- Posts: 31
- Joined: Wed Mar 05, 2008 3:47 pm
- Location: University of North Carolina
by SébastienVillemot » Mon Jul 28, 2008 9:29 pm
Hi,
Just before the error message, you should have an indication of the line and column numbers where the error was triggered.
It is something of the form: "x.y-z" where x is the line number, y and z are column numbers indicating the beginning and the end of the faulty piece of code.
Best
Sébastien
Just before the error message, you should have an indication of the line and column numbers where the error was triggered.
It is something of the form: "x.y-z" where x is the line number, y and z are column numbers indicating the beginning and the end of the faulty piece of code.
Best
Sébastien
- SébastienVillemot
- Posts: 706
- Joined: Fri Dec 07, 2007 2:29 pm
- Location: Paris, France
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest