Hi There,
Using Dynare 4.0.2 in MATLAB, and trying to do a Bayesian estimation. When I run my code, after computing the steady state Dynare spits out the line:
You did not declare endogenous variables after the estimation command.
What does this mean? I declared my endogenous variables at the beginning of the .mod file. Why would I declare them again after the estimation command?
Thanks,
AS
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Declare endogenous variables after the estimation command ?
Forum rules
As Dynare 4 is the current Dynare version, there forum is now close. Post new question in the Dynare Help Forum.
As Dynare 4 is the current Dynare version, there forum is now close. Post new question in the Dynare Help Forum.
2 posts
• Page 1 of 1
Declare endogenous variables after the estimation command ?
by shwayder » Fri Dec 05, 2008 1:46 am
- shwayder
- Posts: 7
- Joined: Wed May 14, 2008 2:28 am
- Location: Northwestern University
Re: Declare endogenous variables after the estimation command ?
by Saint1106 » Mon Dec 15, 2008 1:16 pm
Yes, same problem. What is going on? Apparently without this extra declaration, the moments varendo takes a very long time. Help? Ideas?
- Saint1106
- Posts: 11
- Joined: Wed Feb 23, 2005 12:37 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests