Hi
I have a model with temporary and permanent productivity shocks. I normalized the standard deviations of shocks as 1%. I have been told this is fine if I have each one seperately but if I have both shocks in the same model, then I need to know which one is more important and has a higher sigma. How I can do that? Any suggestions are appreciated!
Best,
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
standard dev. of shocks
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
standard dev. of shocks
by econphd » Mon Jun 12, 2017 3:05 pm
- econphd
- Posts: 31
- Joined: Fri Mar 25, 2016 2:39 pm
Re: standard dev. of shocks
by jpfeifer » Mon Jun 12, 2017 6:17 pm
There is no general advice here. Maybe you could do indirect inference, i.e. try to match some moments
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests