Loop and dynasave

[aless]

Hi,
I loop over some parameters (following the procedure described at http://www.dynare.org/DynareWiki/HowtoLoops) and I would like to save the results for the endogenous variables at each iteration. Is there a way to do it? (dynasave only keeps the results for the last iteration).

Otherwise, is it possible to achieve this using the macrolanguage?

Many thanks!

Alessandro

[SébastienVillemot]

Hi,

I don't know what you want to save, but it should be possible anyways.

The problem with "dynasave" is that you must give it a different filename at each iteration. This is not possible using the standard "for" loop as described on the wiki page you mention.

So you must indeed use the macro-processor in that case.

Your code could look like:

Code: Select all

rhos = 0.8:0.05:1.05;
@#for i in 1:3
 rho = rhos(@{i});
 stoch_simul(order=1);
 if info;
   disp(['Computation fails for rho = ' num2str(rho)]);
 end;
 dynasave savedresults@{i};
@#endfor;


Best,

[aless]

Many thanks for the suggestion!

Best

Alessandro