I am working with matlab through UNIX. What do I have to do in order to install Dynare?
Second question - is the Matlab student version enough? what toolboxes do I need?
Thanks a lot.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
UNIX & Matlab
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
UNIX & Matlab
by yanivyl » Tue Sep 12, 2006 1:39 am
- yanivyl
- Posts: 2
- Joined: Sun Sep 10, 2006 3:02 am
by MichelJuillard » Wed Sep 13, 2006 7:18 pm
In order to run Dynare under Unix or Linux, you need to do the following
1) grab the latest snapshot
2) recompile the parser in directory parser.src with the following command:
make -f Makefile.linux
If something goes wrong check whether Makefile.linux matches your installation
3) If you encounter library problems with the mjdgees or gensylv, delete
mjdgees.mexglx and gensylv.mexglx Dynare will then switch to slower Matlab routines
I will post later instructions on how to recompile mjdgees.mexglx and gensylv.mexglx
Best
Michel
1) grab the latest snapshot
2) recompile the parser in directory parser.src with the following command:
make -f Makefile.linux
If something goes wrong check whether Makefile.linux matches your installation
3) If you encounter library problems with the mjdgees or gensylv, delete
mjdgees.mexglx and gensylv.mexglx Dynare will then switch to slower Matlab routines
I will post later instructions on how to recompile mjdgees.mexglx and gensylv.mexglx
Best
Michel
- MichelJuillard
- Posts: 680
- Joined: Thu Nov 18, 2004 10:51 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests