ERROR 108

[adeem]

Hi there,

I am using matlab 7.9.0 (R2209b). I am receiving the following error whilst running my test.mod file ( take note that I had written code in Notepad and then saved it in ...\Dynare\work folder.
>> cd \\comm2\Documents_redirect$\ak683\Dynare\work
>> cd

\\comm2\Documents_redirect$\ak683\Dynare\work

>> dynare test

Configuring Dynare ...
[mex] Generalized QZ.
[mex] Sylvester equation solution.
[mex] Kronecker products.
[mex] Sparse kronecker products.
[mex] Bytecode evaluation.
[mex] k-order perturbation solver.
[mex] k-order solution simulation.

??? Error using ==> dynare at 108
DYNARE: can't open test.mod

>> dynare test.mod

Configuring Dynare ...
[mex] Generalized QZ.
[mex] Sylvester equation solution.
[mex] Kronecker products.
[mex] Sparse kronecker products.
[mex] Bytecode evaluation.
[mex] k-order perturbation solver.
[mex] k-order solution simulation.

??? Error using ==> dynare at 108
DYNARE: can't open test.mod

Kindly advise.

Adeem

[AssiaEzzeroug]

Hi,

you should check the path, in particular if your mod file "test" is in the repertory "work". Type for instance: "ls" in the command window of matlab to be sure.

Best

[adeem]

Thank you indeed.

Now I am facing the following problem, Is there a problem with my .mod file?

>> dynare test

Configuring Dynare ...
[mex] Generalized QZ.
[mex] Sylvester equation solution.
[mex] Kronecker products.
[mex] Sparse kronecker products.
[mex] Bytecode evaluation.
[mex] k-order perturbation solver.
[mex] k-order solution simulation.

Warning: DOS programs may not execute correctly when the current directory is a UNC pathname.
> In dynare at 122
'\\comm2\Documents_redirect$\ak683\Dynare\work'
CMD.EXE was started with the above path as the current directory.
UNC paths are not supported. Defaulting to Windows directory.
Starting Dynare (version 4.1.1).
Starting preprocessing of the model file ...
ERROR: Could not open file: test.mod

??? Error using ==> dynare at 126
DYNARE: preprocessing failed

Kindly advise.

Adeem