Hi everyone,
I would like to know if there is a command that would allow me to get three IRF in a single figure.
Thank you for your help
Best
Mohamed
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Question about IRF
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
3 posts
• Page 1 of 1
Re: Question about IRF
by jpfeifer » Fri Jun 04, 2010 6:14 am
Hi,
if you mean IRFs for three different variables, the answer is
If you want IRF to three different shocks for one variable, there is no single command. You would have to print IRFs yourself from the results structure oo_.irfs in the workspace.
if you mean IRFs for three different variables, the answer is
- Code: Select all
stoch_simul(irf=20) c y n;
If you want IRF to three different shocks for one variable, there is no single command. You would have to print IRFs yourself from the results structure oo_.irfs in the workspace.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
Re: Question about IRF
by moh » Fri Jun 04, 2010 8:07 am
Dear JPfeifer, thank you very much for your reply.
best
mohamed
best
mohamed
- moh
- Posts: 12
- Joined: Fri Jan 29, 2010 9:16 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests