Hi there,
What is the order of shocks and endogenous variables in the .mat file of the shock decomposition command? In addition, if the number of shocks is K, the file comes with K+2 variables in the shock-dimension. I figure one of them corresponds to the initial value. But what about the other? Thanks a lot, Fabia
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Shock decomposition
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Shock decomposition
by fabiac » Sun Jun 27, 2010 9:37 pm
- fabiac
- Posts: 23
- Joined: Sun Jun 27, 2010 3:35 pm
Re: Shock decomposition
by fabiac » Mon Jul 05, 2010 7:24 pm
I got the answer from Juillard. The first K variables are the values for each of the smoothed shocks. The K+1 correspond to the initial value. The K+2 refer to smoothed values.
And it's not a .mat file. It's in oo_.shock_decomposition
And it's not a .mat file. It's in oo_.shock_decomposition
- fabiac
- Posts: 23
- Joined: Sun Jun 27, 2010 3:35 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests