In which circumstances would you prefer to use mode_compute=6 rather than the other mode_compute options in estimating a DSGE model?
Can one be more sure to get closer or even at the "global optimum" with mode_compute=6 as compared with the other esimtation options?
Thanks and best regards,
George
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Mode_compute=6
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Mode_compute=6
by George » Tue Jul 06, 2010 12:50 pm
- George
- Posts: 25
- Joined: Thu Aug 14, 2008 11:36 am
Re: Mode_compute=6
by coot » Wed Jul 07, 2010 4:34 am
monte carlo optimization routine (monde_compute=6) is not an optimization routine, or a very inefficient one.... so, nope it doesn't gurantee you that you'll get to global minimum, and I don't know even if you should hope... you can read more on it at dynare wiki.... usually mode_compute=6 is used when other optimization routines fail to provide an optimial value with a positive definite hessian matrix.
- coot
- Posts: 24
- Joined: Tue Apr 20, 2010 10:54 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests