Some of the parameter names (even very innocent ones) seem to be generating an error in my code. The attached code, for example, works just fine. But when I replace parameter name "theta" with a parameter name "lambda" (using Replace All function, I get 20 replacements), I get an error message saying that: "The input character is not valid in MATLAB statements or expressions".
Any suggestions would be very much appreciated.
Many thanks,
tokhir
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Some parameter names generate errors
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
3 posts
• Page 1 of 1
Some parameter names generate errors
by tokhir » Wed Oct 18, 2006 9:57 pm
- Attachments
-
OP_model.mod- (2.38 KiB) Downloaded 86 times
- tokhir
- Posts: 7
- Joined: Wed Sep 20, 2006 6:01 pm
by MichelJuillard » Thu Oct 19, 2006 5:56 am
I can't reproduce the problem. OP_model.mod works on my machine in Dynare version 3 and in version 4 under Windows. Under which operating system are you working? which Matlab version ?
Best
Michel
Best
Michel
- MichelJuillard
- Posts: 680
- Joined: Thu Nov 18, 2004 10:51 am
by MichelJuillard » Fri Oct 20, 2006 7:15 pm
The problem is with upper and lower case. For example, you can't have v1 as a parameter and V1 as a variable. There is some inconsistency in the handling of upper and lower case in Dynare version 3. So you should be case consistent, but not rely on it to distinguish objects.
Kind regards
Michel
Kind regards
Michel
- MichelJuillard
- Posts: 680
- Joined: Thu Nov 18, 2004 10:51 am
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests