Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
zero acceptance rate
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
zero acceptance rate
by fabiac » Fri Nov 26, 2010 12:32 pm
I'm running a bayesian estimation with mode 6 in Dynare 4.1.3 with Matlab R2009a. Metropolis gets started and runs with good acceptance rates, but sometimes after a while it reaches a point where acceptance rates go to zero. After they go to zero, they do not converge back to normal value of acceptance rates. It does not seem to be a problem with the mod file because it ran well in other attempts. Does anybody have a clue on what might be happening? Could it be a problem with the memory of the machine? Thanks a lot
- fabiac
- Posts: 23
- Joined: Sun Jun 27, 2010 3:35 pm
Re: zero acceptance rate
by jpfeifer » Wed Dec 01, 2010 7:25 am
Hi,
try plotting the draws in this case. It may be that the MCMC runs to the boundary of the stability region or to the prior bounds. All new draws are then discarded because they violate the Blanchard-Kahn conditions or the prior.
try plotting the draws in this case. It may be that the MCMC runs to the boundary of the stability region or to the prior bounds. All new draws are then discarded because they violate the Blanchard-Kahn conditions or the prior.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 7 guests