Hello,
I have composed a two equation model for illustrative purpose. I have attached the file. I want to solve for the steady state (the time leads and lags do not matter), however, I get an error message: “STEADY: numerical initial values incompatible with the following equations”.
I want to use the hybrid Philips curve in a nonlinear model. However, due to the problem I have described to you I cannot compute the steady state.
I would appreciate if you could help me. Thank you!
Best regards,
Rasa
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
STEADY: numerical initial values incompatible with the foll
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
3 posts
• Page 1 of 1
STEADY: numerical initial values incompatible with the foll
by Rasa » Sat Jan 29, 2011 1:04 pm
- Attachments
-
toy_model.mod- (428 Bytes) Downloaded 155 times
- Rasa
- Posts: 3
- Joined: Fri Jan 28, 2011 2:06 pm
Re: STEADY: numerical initial values incompatible with the foll
by jpfeifer » Sun Jan 30, 2011 11:23 am
The initval block has to be before the steady-command as otherwise all initial values are still 0 when the steady state is computed.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
Re: STEADY: numerical initial values incompatible with the foll
by Rasa » Sun Jan 30, 2011 2:05 pm
Thank you! Yes, you are right. I did not notice that I switched the two statements.
- Rasa
- Posts: 3
- Joined: Fri Jan 28, 2011 2:06 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests