Dear,
I need the help to find some error.
The error is that initial vaule is not incompatible with equations.
I am trying to figure it out. But still do not get it.
Thank you.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
need help
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
need help
by chahj78 » Thu May 05, 2011 4:50 am
- Attachments
-
optimal.mod- (1.43 KiB) Downloaded 121 times
- chahj78
- Posts: 1
- Joined: Thu May 05, 2011 4:47 am
Re: need help
by jpfeifer » Sun May 08, 2011 8:28 am
The error message results from division by 0. As you did not specify an initval-block, all variables are initialized to 0.
Moreover, you FOCs are most probably wrong. Consider for example the term in the second model equation:
In the non-stochastic steady state, PSI and v are both 0. Hence, in the steady state computation,
results in a division of 0 by 0. This gives you the error message for equation 2.
Moreover, you FOCs are most probably wrong. Consider for example the term in the second model equation:
- Code: Select all
(phi_c+PSI/(v/(1-rho_lambda^2)))
In the non-stochastic steady state, PSI and v are both 0. Hence, in the steady state computation,
- Code: Select all
PSI/(v/(1-rho_lambda^2))
results in a division of 0 by 0. This gives you the error message for equation 2.
- jpfeifer
- Posts: 6940
- Joined: Sun Feb 21, 2010 4:02 pm
- Location: Cologne, Germany
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 12 guests