Hi,
Is it possible to have Dynare .mod file import the parameters values from an external file (i.e., a Matlab mat file)?
Thank you
N.
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Import parameters values in Dynare mod file
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Import parameters values in Dynare mod file
by nborri1 » Wed May 11, 2011 2:57 pm
- nborri1
- Posts: 1
- Joined: Fri Oct 10, 2008 4:07 pm
- Location: Boston
Re: Import parameters values in Dynare mod file
by SébastienVillemot » Tue May 24, 2011 10:36 am
There is no command for doing that out of the box, but it is nevertheless feasible with some programming.
There are several ways of doing that that you could try:
There are several ways of doing that that you could try:
- load your MAT file from your MOD file, and repeatedly use the "set_param_value" command
- alternatively, write a MATLAB program which creates a text file containing the parameter assignations, and include that generated file from the top-level MOD file using the "@#include" macro-processor command
Sébastien Villemot
Economist at OFCE – Sciences Po
Economist at OFCE – Sciences Po
- SébastienVillemot
- Posts: 706
- Joined: Fri Dec 07, 2007 2:29 pm
- Location: Paris, France
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 12 guests