I know there are lots of posts regarding the Blanchard Kahn conditions, and I've read through lots of them. My problem is really confusing and non-representative though.
When I put in the original model, dynare gives me warning about Blanchard Kahn condition (Blanchard Kahn conditions are not satisfied: indeterminacy), but when I put in log-linearized model, dynare is able to simulate with no warning message.
I checked over and over again. I am sure there is no timing problem or any redundancy of equations.
Please help me out.
Attached are nonlinear model (every variable is log difference from its steady state) and linear model (every variable is log difference from its steady state) and the files of the steady state.
Thank you for your time
Sincerely
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
Blanchard Kahn conditions
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
2 posts
• Page 1 of 1
Blanchard Kahn conditions
by BBCH » Wed Dec 07, 2011 2:54 am
- Attachments
-
nonlinear_steadystate.m- (3.1 KiB) Downloaded 127 times
-
- nonlinear.mod
- (13.52 KiB) Downloaded 231 times
-
- linearmodel_steadystate.m
- (2.82 KiB) Downloaded 124 times
-
- linearmodel.mod
- (9.09 KiB) Downloaded 147 times
- BBCH
- Posts: 2
- Joined: Wed Dec 07, 2011 2:41 am
Re: Blanchard Kahn conditions
by zlg122 » Tue Jan 10, 2012 8:48 am
I run this code on version 4.1.2 is ok without bugs!
- zlg122
- Posts: 6
- Joined: Thu Dec 29, 2011 7:27 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests