Hi,
I recently downloaded dynare 4.2.4 and had trouble with estimating the correlations of shocks with the CORR notation. Estimation of parameters and standard deviations of shocks are reported without a problem. For some reason, however, the alignment of the result table for correlation of shocks is all screwed up. In addition, the program reports "w=5" several times after the estiamtion is completed, which also does not make sense to me. I was wondering if there is a way to fix this. I tried with MATLAB 2006a and 2010a and both had the same problem. Previous versions of dynare were deleted before installing 4.2.4. A sample code and data file I used is attached. Any help will be greatly appreciated.
Sincerely,
Casey
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
estimating correlation of shocks
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
1 post
• Page 1 of 1
estimating correlation of shocks
by caseyohtsu » Wed Mar 07, 2012 9:22 pm
- Attachments
-
data_bcajp.m- (5.9 KiB) Downloaded 95 times
-
- bcabayesjp.mod
- (2.71 KiB) Downloaded 114 times
- caseyohtsu
- Posts: 2
- Joined: Thu Mar 08, 2007 12:10 pm
1 post
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 9 guests