Hello,
I am working through Chapter 3 of the User Guide to create a .mod file. I have created said file, however, when I try to run it I get the following error: Everytime I try to adjust the error and re-run, another error will appear, for example;
ERROR: test.mod:48.1-11: syntax error, unexpected NAME, expecting CORR or END or VAR
??? Error using ==> dynare at 114
DYNARE: preprocessing failed
I have attached the .mod file I created, if anyone could help?
Thanks so much,
Sashe86
Dynare forums
Forums for asking questions, posting comments and uploading examples related to Dynare
.mod file error???
Forum rules
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
This forum is closed. You can read the posts but cannot write. We have migrated the forum to a new location (https://forum.dynare.org) where you will have to reset your password.
3 posts
• Page 1 of 1
.mod file error???
by sashe86 » Thu Apr 05, 2012 2:06 pm
- Attachments
-
test.mod- (1.39 KiB) Downloaded 65 times
- sashe86
- Posts: 24
- Joined: Tue Apr 03, 2012 4:14 pm
Re: .mod file error???
by bkjecn » Thu Apr 05, 2012 2:28 pm
You have two syntax errors:
1) You need to end the shocks block. That is, put a line reading 'end;' after the line 'var e = sigma^2;%add a shock with variance sigma squared.'.
2) You should not have a '==' in the stoch_simul command. Use only one '='.
1) You need to end the shocks block. That is, put a line reading 'end;' after the line 'var e = sigma^2;%add a shock with variance sigma squared.'.
2) You should not have a '==' in the stoch_simul command. Use only one '='.
- bkjecn
- Posts: 35
- Joined: Thu Oct 13, 2011 3:02 am
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests